Sangean U-3 Instruction Manual download pdf (Page 15)

Setting tuning step

Tuning steps on some countries are different from where you

purchase the radio. If you buy the radio in Europe and intend to

use in Northern America or some Southern American countries,

you may have to adjust tuning step so the radio may continue to

serve you well.

While radio is switched off, long press Step/Band button for

more than 2 seconds will first show current FM tuning step.

Continue pressing Step/Band button for approx. another 5 seconds

until display FM and 50 kHz (tuning step) flashing followed by a beep.

By rotate Tuning Control knob, you may adjust to 100 kHz per tuning

step.

After FM tuning step is reset, pressing Step/Band button again,

display will show MW and flash 9 kHz. By rotate Tuning Control knob,

you may adjust to 10 kHz per tuning step. Complete the setting by

pressing Step/Band button.

Aux and Headphones sockets

1. The Aux socket (3.5 mm) on the right side of your radio is for

use with a tape recorder/mini disc or any other equipment that

can provide a line level signal. Inserting a plug into the socket

automatically mutes the internal signal. And Aux LED will be on.

The Volume and Tone control can be used to adjust sound level.

2. The Headphone socket (3.5 mm) located on the right side of your

radio is for use with either headphones or an earphone. Inserting

the headphone plug automatically mutes the internal loudspeaker.

1 2 ... 10 11 12 13 14 15 16 17 18 19

No comments

Sangean U-3 Instruction Manual Page 15