Sangean U-3 Instruction Manual download pdf (Page 12)

Note:

Radio alarm can be activated only until both radio alarm time and

radio alarmed station are set. Radio alarm will be automatically

switched to Buzzer alarm when the radio is in low battery status

or the selected radio alarm station signal is too weak.

a. Setting radio alarm time:

1. The radio alarm can be set either radio is on or off.

2. Press and release radio alarm button , the radio alarm symbol

will flash.

3. During radio alarm flashing, press Tuning control/Scan/Time Set

knob for more than 2 seconds followed by a beep tone.

4. Display Hour will flash, rotate Tuning Control knob to select the

hour then press in Tuning control/Scan/Time Set knob again to

confirm hour setting.

5. Follow same procedure of setting hour to set required minute.

Press Tuning Control/Scan/Time Set knob again to complete

alarm time setting.

b. Setting radio alarmed station:

1. During setting radio alarm time and radio alarm symbol is flashing,

press Band button to activate the radio to select required wake-up

band and station by manual tuning and recall preset stations.

2. When above radio alarm time and station are set, press and hold

radio button for 2 seconds followed by a beep tone to switched

alarm on or off. Display will show when radio alarm is set.

Note:

If new radio alarm station is not selected, it will select the last

alarm station.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

No comments

Sangean U-3 Instruction Manual Page 12