Sangean U-3 Instruction Manual download pdf (Page 11)

Storing stations in preset memories

There are 5 memory presets for each waveband.

1. Press the Power button to turn on the radio.

2. Tune to required station using one of the methods previously

described.

3. Press and hold down the required preset until the radio beeps.

The preset number will appear in the display and the station will

be stored under chosen preset button.

4. Repeat this procedure for the remaining presets.

5. Stations stored in preset memories can be overwritten by

following above procedures.

Recalling stations from preset memories

1. Press the Power button to turn on the radio.

2. Select the required waveband.

3. Momentarily press the required Preset button, the preset number

and station frequency will appear in the display.

Setting the radio alarm

When the radio alarm is selected, the radio will turn on and play the

chosen radio station at the chosen alarm time. The radio alarm will

continue for one hour unless turned off by pressing the Power button.

Press the Power button whilst the alarm is activated will cancel the

alarm for 24 hours.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

No comments

Sangean U-3 Instruction Manual Page 11