Sangean DDR-22 Specifications download pdf (Page 9)

Operating your radio

1. Press the On / Standby button to switch on your radio. The display

will show “TUNING” for a few seconds.

When first switched on, the radio will be in DAB mode. After each

use the radio will remember the last mode used and then switch on

in that mode the next time that it is used.

2. If the radio has been used before, the last used station will

be selected.

3. If this is the first time that the radio has been used, then the first

station in the list of stations found during scanning will be played.

The display will show the station name on the display.

4. If no signals are found then “OFF AIR” will be displayed and it may be

necessary to relocate your radio to a position giving better reception.

You should then carry out a scan to find stations as described

on the subject as “Display modes – DAB”.

Your radio has an indicator on the display to indicate the

strength of the DAB radio signal being received.

Note:

When first switched on, the radio will set the volume to a moderately

high level, in case the broadcast is very quiet. After you have set the

volume using the Volume Up or Down buttons, the radio will remember

the setting that you have applied for the next time that it is used.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 40 41

No comments

Sangean DDR-22 Specifications Page 9