Sangean DDR-22 Specifications download pdf (Page 26)

Setting the alarm times - (continued)

In addition to the above procedure of setting the alarm times, you can

also operate following the steps below.

1. Press the On / Standby button to switch on the radio.

2. To set the alarm times, press the Menu button to enter the

setup menu. “MANUAL” will appear on the display.

(“MANUAL” won’t appear on the display if you put the radio into

FM mode.)

3. Press the Tuning Up or Down button until “CLOCK” appears on

the display. Press and release the Select button.

4. Press the Tuning Up or Down button until “SET ALM” appears on

the display.

5. Press and release the Select button to enter the procedure for

setting the alarm times as shown on the subject as “Setting the

alarm times”.

Important:

If using your iPod as the source for the alarm, then be sure to dock

your iPod, otherwise the source for the alarm will change to

buzzer automatically. Besides, if using your DAB as the source for

the alarm, and your DAB has no signal, the source for the alarm will

also change to buzzer automatically. After docking, briefly switch on

the radio using the On / Standby button and then select iPod mode

using the Mode button. Next, press the Play / Pause button two or

three times to ensure that the radio and your iPod are communicating

correctly. Failure to verify this may result in the alarm not being audible

if the radio is unable to activate your iPod when needed. When ready,

put the radio back into standby mode using the On / Standby button.

Cancelling alarms

1. While an alarm is sounding it can be cancelled by pressing the

On / Standby button.

2. To cancel an alarm at any other time, enter the alarm setup menu and

set the alarm On/Off option to “Off”. See steps 1 - 5 on the subject

as “Setting the alarm times”.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 40 41

No comments

Sangean DDR-22 Specifications Page 26