Sangean PR-D1 Service Manual download pdf (Page 5)

Time set

For the first time to operate this radio ,display will show "--:--"

after you installed the batteries . Press TIME SET button display will

show TIME SET and clock flashes'0:00' or 'AM 12:00'. Press HOUR

adjustment button and MINUTE adjustment button to set the time

Press TIME SET button again to finalize the time setting ,The clock will

start from 0 second.

If CLOCK AUTO ADJUST switch set to ON position ,while turn on the

radio and receiving FM stations with RDS CT (clock time) function ,the

clock will be adjusted by RDS CT signal automatically.

Note :While receiving RDS signal, display will show RDS symbol ,however

it is not always the RDS station broadcasting CT signal

Before the time is set ,it is not possible to set the alarm (standby)

time.

Alarm time (Standby) set

Press STANDBY button ,alarm mode will appear BUZZER ,LAST CH ,and time

will flash ,First select the alarm mode by pressing STANDBY button

again to have alarm by buzzer STANDBY or alarm by radio

(last radio fuequency will appear )or alarm off

During time flash ,using HOUR and MINUTE to set the alarm time,then press

Standby button again.Display Buzzer or LAST CH.or setted frequency will

disappear within 4 seconds and only appear STANDBY- (Alarm by buzzer)or

-STANDBY(alarm by radio).

When alarm on,press Power/Sleep button or STANDBY button to switch off,

and back to its Standby status.

Alarm will last for one hour before it is switched off.If radio is on and

alarm on,the radio will sound BI BI and display alarm by radio symbol

will flash.

Snooze

When alarm on,press any operational key except STANDBY, POWER and LOCK

it will be into SNOOZE status, display will appear and the alarm

will sound again after about 5 minutes. This cycle will be repeated for

1 hour unless to switch off the alarm

1 2 3 4 5 6 7 8

No comments

Sangean PR-D1 Service Manual Page 5