Sangean DDR-22 Specifications download pdf (Page 7)

Operating your radio - DAB

1. Fully extend the telescopic aerial. Fully extend the telescopic aerial

located on the rear of your clock radio. Place the telescopic antenna

so that it is as vertical as possible extending either above or below

the radio.

2. Insert the adaptor plug into the DC socket located on the rear of your

clock radio. Plug the adaptor into a standard mains outlet.

The display will show “Welcome to Digital Radio” for a few seconds

and then the display will show “Time is not set”. (If the radio has been

used before the radio is to find a clock radio stations. After a while

the current time will appear on the display.)

3. Press and release the On / StandBy button to switch on your clock

radio.

4. During the scanning process, the lower line of the display shows a

bar-graph indicating progress of the scan.

5. If the radio has been used before, the last used station will be selected.

6. When the scanning is completed the rst station (in numeric-alpha

order 0...9...A....Z) will be selected.

7. If this is the rst time that the radio has not been used, then the rst

station in the list of stations found during scanning will be played.

The display will show the station name on the display.

8. If the station list is still empty after the Auto tune your clock radio will

display “No DAB Station”.

9. If no signals are found it may be necessary to relocate your clock

radio to a position giving better reception.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

No comments

Sangean DDR-22 Specifications Page 7